Solutions
Automatic CIP systems circulate cleaning solutions through suitable production equipment, with controls designed around your application.
Tanks, pipework, pumps, filters, fillers and rinsers can form part of a CIP project. We review the equipment, cleaning recipes, operating parameters and connections before defining the system.
Discuss your projectElectric heating elements, heat pumps and steam heat exchangers are possible heating options. Heating capacity and the supply pump are sized for the thermal requirements, expected flow rate and pressure.
Provide circuit volumes, pipe lengths and diameters, the equipment to be cleaned and the required cleaning sequences. Existing protocols, cleaning chemicals, temperatures and utility information help define the configuration.
Explore the range
An automatic cleaning-in-place system with 2 tanks of 250 L each, for food and beverage production equipment.
ExploreAn automatic cleaning-in-place system with 2 tanks of 500 L each, for food and beverage production equipment.
ExploreAn automatic cleaning-in-place system with 2 tanks of 1,000 L each, for food and beverage production equipment.
ExploreAn automatic cleaning-in-place system with 3 tanks of 2,000 L each, for food and beverage production equipment.
Explore
A manually operated cleaning-in-place solution for suitable production equipment.
ExploreCompare configurations
Tank volume is a starting point. The choice also depends on circuit volume, circulation flow and pressure, the cleaning protocol and heating requirements.
| Model | Tanks | Indicative electric heating |
|---|---|---|
| EZCIP 22.5 ↗ | 2 × 250 L | 9 kW |
| EZCIP 25.0 ↗ | 2 × 500 L | 12 kW |
| EZCIP 210.0 ↗ | 2 × 1 000 L | 24 kW |
| EZCIP 320.0 ↗ | 3 × 2 000 L | Subject to design study |
The stated powers refer to electric heating elements. Heating can also use a heat pump or steam heat exchanger and is sized for the application. The supply pump is selected for the required flow rate and pressure.
Prepare the information for sizing ↗Useful questions
CIP applies to circuits suitable for circulating cleaning solutions: tanks, pipework, pumps, filters, fillers or rinsers. Equipment, connections and cleaning conditions are assessed during the study.
Tank capacity is one part of the design. The circuit volume, flow rate, pressure, cleaning sequence and heating requirements must also be considered.
Your existing chemicals, concentrations, temperatures, times and rinsing steps provide a starting point. Their suitability for the new system and circuits must be defined and validated for your installation.
We use exclusively high-quality Schneider Electric or Siemens industrial PLCs. All our automatic machines are remotely accessible through Ubiquity; this access is enabled as standard on the automatic EZ range. It uses the network connection available at your site.
A single machine has a 17-inch HMI. A combined system, such as EZCIP + EZF, uses a 27-inch HMI for greater comfort. Centralising control of both machines can save up to €15,000 depending on the configuration, compared with two separate control systems. The amount is specified in the quotation.
Automatic CIP cleaning recipes are open: you can create your own recipes from start to finish, with no restriction on recipe creation. We remain available to advise and help you build them. Parameters and protocols must be adapted and validated for your installation.
Let’s build what comes next
